How Is A Switch Selected As A Root Bridge For Spanning Tree If The Bridge Priorities Are The Same?
How Is A Switch Selected As A Root Bridge For Spanning Tree If The Bridge Priorities Are The Same?. The switch i want to be root i set at a priority of 4096, and set the priority of the switch that i don't want to be root at 20480. After you have added three switches to the workspace in the cisco packet tracer, the spanning tree.
The spanning tree protocol uses the bridge id and the mac address of the switch to elect the root bridge. The priority of the switch is set to the. Posted in spanning tree protocol (stp) in this.
The Switch With The Lowest Ip Address Will Not Be Selected As The Root Bridge By Stp Because The Ip Address Of The Switch Does Not Influence The Selection Of The Root.
If all the spanning tree bridge priority has the same priority value on all the switches, then the mac address will be the tiebreaker. The spanning tree protocol uses the bridge id and the mac address of the switch to elect the root bridge. These messages are called hello bpdu.
A) The Switch With The Lowest Ip Address Will Become The Root.
After reading this root id information from all neighbors, the root bridge will be identified based on the root id values. How is a switch selected as a root bridge for spanning tree if the bridge priorities are the same? The switch with the lowest ip address will become the root bridge.
Bridge Id, Priority, System Id Extension & Root Bridge Election Process.
How is a switch elected as a root bridge for spanning tree if the bridge priorities are the same? The branches (ethernet connections) are then branched out from the root switch, connecting. After the election process, a spanning tree is created, preventing switching loops.
A) The Switch With The Lowest Ip Address Will.
The switch with the lowest ip address will become the root bridge b. Priority and mac address, if you config priority equal to 0 but if other sw also by mistake config with same value then the tie breaker is mac but if the new mac address is best. Posted in spanning tree protocol (stp) in this.
How Is A Switch Elected As A Root Bridge For Spanning Tree If The Bridge Priorities Are The Same?
In my case, sw2 is the root bridge for all vlans: How is a switch selected as a root bridge for spanning tree if the bridge priorities are the same? The switch i want to be root i set at a priority of 4096, and set the priority of the switch that i don't want to be root at 20480.
Post a Comment for "How Is A Switch Selected As A Root Bridge For Spanning Tree If The Bridge Priorities Are The Same?"